Forespar SR-2 Jib Roller [210003]
- Free worldwide shipping
- Low stock - 6 items left
- Inventory on the way
SR-2 Jib Roller
The Forespar® SR-2 Jib Roller with fit shrouds from 3/16” thru 3/8” wire diameter.
Use the proper size pair of insert liners according to the table below:
- 3/8” wire – use no insert
- 5/16” wire – use #1 inserts
- 9/32” wire – use #2 inserts
- ¼” wire – use #3 inserts
- 7/32” wire – use #4 inserts
- 3/16” wire – use #5 inserts
The Jib Rollers may be placed just above or below the spreader tips; however, installation will be easier if located below the spreaders. In this instance, you can pre-assemble the parts while on deck and reduce the possibility of losing parts while hanging in a boatswain’s chair. Have a 3 inch piece of masking tape within handy reach (stick it to the shroud).
Select the proper inserts, place them into the two halves of a hub and fit them around the shroud. Use the tape to loosely hold these parts together. Note that the hubs have two clearance screw holes at one end. Match these with the smaller holes at the other end of the other half. It is important that the mating faces of the inserts are parallel with the faces of the hub halves. Install the four screws supplied, tightening only to the extent that you can still slide the hub assembly up the wire shroud. Now remove the tape.
Next, install the rollers. Note that one half of each roller has clearance holes for the two screws. Mate these halves that don’t have clearance holes. Run these screws tight. Now slide the Jib Roller to the desired position on the shroud and finish tightening the four hub screws until the hub interfaces are fully closed.
30-Day Returns & Fast Shipping
Most eligible items may be returned within 30 days of delivery. Items must be unused, uninstalled, and returned in their original condition with all original packaging, accessories, hardware, and components.
Returns caused by ordering the wrong item, incorrect vehicle or product fitment, incorrect size or quantity, accidental purchase, change of mind, or other customer error are subject to a minimum 20% restocking fee. Depending on the condition of the returned product, packaging, missing components, or other factors affecting resale value, the restocking fee may be increased up to a maximum of 50% of the product price. Customer-error returns may also be subject to return shipping costs.
Restocking fees do not apply when we verify that the wrong item was shipped by us or that the product arrived damaged or defective through no fault of the customer. Please contact 4Falcons before returning any item so we can provide return authorization and instructions.
Orders are processed and shipped as quickly as possible. Delivery dates are estimates and may be affected by carrier delays, weather, holidays, incorrect addresses, or other circumstances outside our control. Tracking information will be provided when available.
Please verify vehicle, RV, marine, or equipment compatibility before placing your order. Installed, used, modified, damaged, incomplete, or otherwise non-resalable products may receive a reduced refund or may not be eligible for return.
